healeys
[Top] [All Lists]

Re: [Healeys] Fitting Front Shroud

To: <ah1006@verizon.net>, <healeys@autox.team.net>
Subject: Re: [Healeys] Fitting Front Shroud
From: andy pole <ampole@hotmail.com>
Date: Sat, 6 Jun 2009 06:30:53 +0000
Tom (assuming a 3000)



It is common for the bottom holes in the ali to disappear over the years due
to electrolytic conversion of steel against ali. Heres a pic of my shroud with
them missing:



http://www.austin-healey3000.com/apps/photos/photo?photoid=5125453



The shroud when fitted is aligned on the bonnet front edge by the 3 holes that
correspond with the 3 holes in the chassis crossmember, (look at the inner lip
of the shroud bonnet opening) as well as the side inner wing brackets. This
pic shows the chassis with the 3 holes in the top edge that have screw fixing
the chassis to the shroud:



http://www.austin-healey3000.com/apps/photos/photo?photoid=5131330



Hers a pic of the shroub bottom bolts (you might have to click on the fullsize
tab at the bottom right of the photo to get it to show all of the photo
depending on your browser settings):



http://www.austin-healey3000.com/photos/Paint/healey%20031.JPG



hope that helps

Andy


_________________________________________________________________
With Windows Live, you can organise, edit, and share your photos.
http://clk.atdmt.com/UKM/go/134665338/direct/01/
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>