healeys
[Top] [All Lists]

Re: [Healeys] Footwell Heat shield 100 BN2 -spacers and washers

To: "Thomas Willig" <twillig@ruda.de>, <healeys@autox.team.net>
Subject: Re: [Healeys] Footwell Heat shield 100 BN2 -spacers and washers
From: "Rich C" <richchrysler@quickclic.net>
Date: Mon, 13 Jul 2009 07:56:59 -0700
Thomas,

All insulating panels on all Hundreds were installed flat against the metal 
with no spacers. The 1" square stand-offs were not installed until the MK 2 
3000's.

In addition, there was no insulating panel originally under the floor above 
the muffler on any Hundreds.

The large washers that come in the popular commercial kits have the right 
i.d and o.d. but are too thin. Clarke Spares & Restorations 
ClarkeSpares@worldnet.att.net
have just tooled up to produce these washers with the correct thickness.

Rich Chrysler

----- Original Message ----- 
From: "Thomas Willig" <twillig@ruda.de>
To: <healeys@autox.team.net>
Sent: Monday, July 13, 2009 1:45 AM
Subject: [Healeys] Footwell Heat shield 100 BN2 -spacers and washers


> Were are the 1" square spacers on  the "asbestos" heat shield on the BN2
> used:
>
> On all pieces?
> No spacers at all?
> Only on the shield above the muffler?
>  Where can I get the big washers with only a 3/16" center hole which are
> used to attach the heat shield to the body?
> Thanks
>  Thomas Willig
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>