The Nocks have a floor bolted bracket that allows the seat belt bracket
to be perpendicular to the floor. I just installed a set of them.
John
John Loftus wrote:
> Hi all,
>
> I'm trying to sort out my 3 point type seat belts on the BJ7. My
> understanding is the drive shaft tunnel has an eyelet anchor point
> (eyelet bolted to side of tunnel). The short belt (with buckle) is
> attached to the eyelet with a hook type clasp.
>
> My question concerns the outboard attachment. Is that also supposed to
> be a hook type clasp going to an eyelet? Or does the outboard belt
> just bolt directly to the floor? My belts have just a simple single
> hole bracket for this end. I could bolt this to the floor but then the
> belt routing isn't great i.e. it would be better if the belt bracket
> was perpendicular to the floor.
>
> The factory service bulletin A-437
> <http://www.healey6.com/bulletins/Seat%20Belt-ASJ.pdf> shows some type
> of 90 degree bracket. But at the same time they don't show any eyelets
> and hook type clasps being used.
>
> They also show the bracket for the rear wheel arch (shoulder belt
> attachment) having a two hole bracket. My belt has just one hole in
> the bracket.
>
> Any guidance appreciated!
>
> Cheers,
> John
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|