healeys
[Top] [All Lists]

Re: [Healeys] Throttle? linkage

To: healeys@autox.team.net, John Sims <ahbn6@verizon.net>
Subject: Re: [Healeys] Throttle? linkage
From: Jaap Aeckerlin <j.aeckerlin@gmail.com>
Date: Tue, 11 Aug 2009 21:33:17 +0200
Now that you all are on the subject: Has anyone ever considered to replace
the linkage system with a Bowden cable and if so, are there any pictures
available? I'm getting fed up with the stupid linkage which always tends to
stick somewhere along the full travel of the gas pedal and would like to
change it into a smooth working set-up.
Jack Aeckerlin, The Netherlands
1964 BJ8 29432

2009/8/11 John Sims <ahbn6@verizon.net>

> My BN6 with HD6's idles just fine at around 800 rpm and the mixture is
> correct as far as I can determine. Problem is that when I accelerate the
> linkage sticks coming down at about 2,000 rpm and stays there. When in the
> cockpit, trying to raise the pedal with my foot does nothing -- it is
> already up as far as it will go.
>
> Under the bonnet, when I goose the linkage by moving the relay shaft to
> carbs, it comes right down where it should at 800 even running past 2,000
> rpm. If I hold this shaft open above 2,000 rpms, it will only come back
> down
> to 2,000 rpm and I have to nudge the shaft to bring it back to 800.
>
> What am I missing???
>
> John Sims, BN6
> Aberdeen, NJ
>
> http://www.healey6.com
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as j.aeckerlin@gmail.com
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>