healeys
[Top] [All Lists]

Re: [Healeys] King pin lubrication

To: "'Rich C'" <richchrysler@quickclic.net>, <healeys@autox.team.net>,
Subject: Re: [Healeys] King pin lubrication
From: "Ron Ray" <ronald-ray@sbcglobal.net>
Date: Sun, 18 Oct 2009 13:17:38 -0500
To allow improved distribution of the grease, upon the suggestion of local
AH club members, when rebuilding the front suspension on my 1959 BT7, we
installed grease fittings on both the front and rear trunnin bushings.  One
just buys two front bushes instead of a front and rear.   The Concours
judges missed this.
 
Ron  
 
 
-----Original Message-----
From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
On Behalf Of Rich C
Sent: Sunday, October 18, 2009 12:33 PM
To: healeys@autox.team.net; Stephen Hutchings
Subject: Re: [Healeys] King pin lubrication
 
Stephen,
 
The lower portion of the king pin is drilled hollow for the grease fitting 
on the very bottom to push the grease up inside the kingpin and out the 
grease hole of the pin to the lined up spiral grease channel in the lower 
bushing.
To review, there are 3 grease fittings per kingpin assembly. one to the 
upper bushing, one (as above) from beneath, feeding up thru the pin to the 
lower bushing, and the third being into the end of the lower trunnion. I 
always assemble these lower trunnin bushings so the grease fitting is on the

forward one, an easier loaction to reach all the grease fittings from one 
position. I also make sure the top and bottom fittings are 45 or 90 degree 
ones so the nipples all face forward.
 
Rich Chrysler
 
----- Original Message ----- 
From: "Stephen Hutchings" <s.hutchings@rogers.com>
To: <healeys@autox.team.net>
Sent: Sunday, October 18, 2009 12:25 PM
Subject: [Healeys] King pin lubrication
 
 
> This has probably come up before, and I have a vague memory of someone 
> complainig about it, but here's my question:
> How the heck is the lower kingpin bushing lubricated, other than upon 
> assembly? Is the grease suppposed to dribble down from the upper bushing? 
> Intuitively, one would expect another grease fitting.
> 
> Stephen, BJ8
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>