healeys
[Top] [All Lists]

Re: [Healeys] speedo change

To: allen c miller jr <acmiller@mhcable.com>
Subject: Re: [Healeys] speedo change
From: John Harper <ah@jharper.demon.co.uk>
Date: Fri, 28 May 2010 14:15:38 +0100
Allen

I have done something similar because I have a 3.454:1 diff in my BN2. 
If you are using a Speedo from a BN4 that also had this rear axle ratio 
then you should be OK.

I cannot remember where my mechanism came from but it had the correct 
flex revs per mile. The other thing to check is that the donor Speedo 
had the same needle degrees per mph. If say 80 mph is the same number of 
degrees around the dial then this is fine. On a BN2 dial, 80 mph is 180 
degrees from 0 mph.

Obviously the speed and distance will still read a little high if you 
use modern tyres with a smaller rolling radius

Regards

>Can anyone advise whether it is possible to have a 100-4 speedo face fitted to
>a later model magnolia speedo that drives off the BN4. I have change my
>gearbox and rear axle to a non-overdrive BN4 tranny and differential, and it
>would seem easiest to simply have a 100-4 black dial speedo face fitted to a
>BN4 - BN7 speedometer case.
>I have a good  magnolia sppedo body that is partially seized up, but I think
>might be restorable. Any thoughts appreciated.
>
>Allen Miller
>BN2/M

-- 
John Harper
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>