healeys
[Top] [All Lists]

Re: [Healeys] Steering arm torque

To: frogeye@porterscustom.com, hgmiller3@qwest.net,
Subject: Re: [Healeys] Steering arm torque
From: "warthodson@aol.com" <warthodson@aol.com>
Date: Fri, 10 Sep 2010 19:35:22 -0400
The steering arm is tapered & splied, but the nut is not. It also does not use
a lock washer. It does use a cotter pin.
Gary Hodson

-----Original Message-----
From: Dave Porter <frogeye@porterscustom.com>
To: 'Herb Miller' <hgmiller3@qwest.net>; healeys@autox.team.net
Sent: Fri, Sep 10, 2010 6:11 pm
Subject: Re: [Healeys] Steering arm torque


Herb,
Just a "WAG" as they say, but if 80 ft lbs is good for lug nuts, I'd guess
00 is sufficient for that nut. Since it is probably both tapered and
plined and uses a lock washer to boot, it isn't going to come apart without
 puller after once being tightened.  Using torque valves is really only
mportant when one needs to have even clamping over a multi-fastener object
r when delicate threads might be damaged from over tightening.
Engineers? Your thoughts..
frogeye@porterscustom.com
Porter Customs   2909 Arno NE
lbuquerque, NM USA 87107
05-352-1378
954 BN2  1959 AN5
orter Custom Bicycles
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>