Stephen,
The central bolt, referred to as a 'toe bolt' in the Moss catalog can be made
from a 1/4" bolt of the desired length. If the bolt head is too large for the
hole in the axle 'shoe', you can turn it down by chucking it in an electric
drill and using a file to round it off until it fits.
The straps can be made from flat steel either 3/4" x 1/8" or 1/2" x 1/8".
Steve Gerow
Altadena, CA USA
BN6
Stephen Hutchings wrote:
>>>From: Stephen Hutchings <s.hutchings@rogers.com>
Subject: [Healeys] Leaf spring parts
To: healeys@autox.team.net
I've noticed that the usual supliers don't offer some of the leaf
spring components, such as the special central pin/bolt that goes
through the middle, or the "clamps" along the length. I plan to keep
my springs, but wanted to separate them and clean them up, and need
to replace some of these bits.
Anyone know of a source?
Stephen, BJ8
<<<
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|