healeys
[Top] [All Lists]

Re: [Healeys] trans buffer

To: healeymanjim@hansencc.net
Subject: Re: [Healeys] trans buffer
From: Austin Healey <pajtamuvek@gmail.com>
Date: Sun, 24 Apr 2011 11:20:58 +0200
Thanks!

2011/4/23 Austin Healey <pajtamuvek@gmail.com>

> Can anybody tell me the aprox thickness of this pad? Only on one side or
> each sides have one?
>
> Gergo
>
> 2011/4/23 <healeymanjim@hansencc.net>
>
> andrea, when i rebuilt the trans in the bn6, i did not know about that
>> buffer and did not replace it.  about a month later it cracked in half (it
>> was some kind of plastic) allowing the high gear rod to move forward enough
>> to allow balls and springs to fly all over inside.  needless to say, had to
>> pull trans and try to figure out problem.  i replaced the plastic piece with
>> leather or rubber (cannot remember exactly) and it has worked fine ever
>> since.  make sure to measure thickness and replace with a material that will
>> not compress too much allowing shift rod to move too far forward.  hjim
>> _______________________________________________
>> Healeys@autox.team.net
>> Donate: http://www.team.net/donate.html
>> Suggested annual donation  $12.75
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>> Unsubscribe/Manage <http://www.team.net/forumsUnsubscribe/Manage>:
>> http://autox.team.net/mailman/options/healeys/pajtamuvek@gmail.com
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>