healeys
[Top] [All Lists]

[Healeys] removing wire harness

Subject: [Healeys] removing wire harness
From: jmsdarch at sbcglobal.net (john spaur)
Date: Sun, 24 Apr 2011 20:00:35 -0700
References: <BANLkTikZZyVPxXx454oKM0vxJzg_Mt47uQ@mail.gmail.com>
You should not have to cut it to remove it. Just pull it into the 
engine compartment. It will help if it is intact to figure out which 
components are related to which connectors on the harness when you 
start to remove original items to install them on the new harness. I 
don't think there are any clips on the transmission other than the OD 
clip which is attached to one of the cover bolts on the center shift 
transmission. There are clips on the screws at the foot well heat 
shield though for the rear harness. They are nearly impossible to get 
to with the engine and trans in place. The wiper motor three-way 
(three bundled but isolated connectors) is made from unobtainium.

John

At 12:47 PM 4/24/2011 -0700, I Erbs wrote:
>...I want to remove my old harness this week... I plan on cutting 
>the harness at the firewall to
>make it easier to remove, VS pulling it through.
>Thanks
>Ira Erbs

<Prev in Thread] Current Thread [Next in Thread>