healeys
[Top] [All Lists]

Re: [Healeys] Front disc brakes locking up after rebuild

To: "Ron Ray" <ronald-ray@sbcglobal.net>
Subject: Re: [Healeys] Front disc brakes locking up after rebuild
From: David Nock <healeydoc@sbcglobal.net>
Date: Mon, 8 Aug 2011 08:24:58 -0700
If both the front wheels are staying on it is unlikely that there is  
a problem in both calipers or caliper hoses. The problem is most  
likely that the master cylinder piston is sticking in that master  
cylinder bore.

If only one wheel is hanging up then the problem is most likely a  
caliper or hose.




David Nock
British Car Specialists
Stockton Ca 95205
209-948-8767

www.britishcarspecialists.com
.
.

On Aug 7, 2011, at 5:23 PM, Ron Ray wrote:

> Folks,
>
> After rebuilding the hydraulic system the front brakes do not  
> release.  If
> the bleed screw is loosened, they do release.
> The rear brakes do not lock up
>
> All rubber hoses were replaced.
> All original steel brake lines were clean with air pressure.
> The connector valve on the passenger side was removed and cleaned  
> with air
> pressure.
> The caliber pistons can be moved by hand when they are off the car.
>
> When the front brakes lock up, the master cylinder piston does not  
> return to
> the full "forward:" position.
>
> Any suggestions would be greatly appreciated.
>
> Thanks
>    Ron
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/ 
> healeydoc@sbcglobal.net
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>