Thanks to everyone for their help and suggestions. I noticed this last
year and thought it was just my imagination. Good to know that the tach is
just slightly off with age and my mind is not.
- Tom
On Fri, Aug 19, 2011 at 10:57 AM, BJ8 Healeys <sbyers@ec.rr.com> wrote:
> Bob, I should have said "repair" instead of rebuild. The needle sometimes
> read high and sometimes low at the same speed. I did not do the repair
> myself, so I don't know for sure; but I think the parts were replaced with
> similar ones and the tach was not modified to "modern electronics."
> I subsequently converted it for negative ground myself, and it appeared
> stock inside to me.
>
> Steve Byers
> HBJ8L/36666
> BJ8 Registry
> Havelock, NC USA
>
> From: Bob Johnson [mailto:bjsbj8@gmail.com]
> Sent: Thursday, August 18, 2011 4:15 PM
> To: BJ8 Healeys
> Cc: healeys@autox.team.net
> Subject: Re: [Healeys] Tach heat sensitive?
>
> Steve, rebuild to old spec with new parts, or with modern technology?
> Bob Johnson
> BJ8
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/ah3000me@gmail.com
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|