healeys
[Top] [All Lists]

[Healeys] Torque spec for BJ7 rear hub nut

Subject: [Healeys] Torque spec for BJ7 rear hub nut
From: bspidell at comcast.net (Bob Spidell)
Date: Wed, 11 Apr 2012 17:01:37 -0700
References: <0FEAF9BEA66B884B8B9DAA4C7135CE605EEB995D3A@MAIL1.ua-net.ua.edu>
140 lb-ft


On 4/11/2012 4:29 PM, Williams, Allen wrote:
> Can anyone tell me the correct torque, if any, for the large thin nut that
> holds the rear hub(bearing carrier)and bearing to the BJ7 axle? I've replaced
> the hub seal, have a new o-ring and axle shaft gasket, so hopefully I won't
> ruin another set of brake shoes.
> I am an infrequent poster here, but really appreciate the help from the list.
> Thanks in advance
> Allen Williams
> BJ7
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/bspidell at 
> comcast.net
>
>


-- 
*******************************************************************
Bob Spidell           San Jose, CA            bspidell at comcast.net

*******************************************************************

<Prev in Thread] Current Thread [Next in Thread>