[Healeys] Torque spec for BJ7 rear hub nut

[awill at ccs.ua.edu (Williams, Allen)]

Holy Cow! I knew it was hard to get off.
Thanks
Sent: Wednesday, April 11, 2012 7:01 PM
To: Williams, Allen
Cc: healeys at autox.team.net
Subject: Re: [Healeys] Torque spec for BJ7  rear hub nut

140 lb-ft


On 4/11/2012 4:29 PM, Williams, Allen wrote:
> Can anyone tell me the correct torque, if any, for the large thin nut that
> holds the rear hub(bearing carrier)and bearing to the BJ7 axle? I've
replaced
*******************************************************************
Bob Spidell           San Jose, CA            bspidell at comcast.net