Thanks Bob for your answer. I've read this, but don't have time to order from
Moss, living on the other side of the "pond". :-)
Peter Ehn.
+46 708 33 72 97
peter.ehn at frontwalker.se
(skickat frC%n min iPhone)
8 maj 2012 kl. 19:27 skrev "Bob Spidell" <bspidell at comcast.net>:
> Can't help on dimensions, but here's some info:
>
> http://www.mossmotors.com/graphics/products/PDF/021-511.pdf
>
> Bob
>
> --------------------------------
> Bob Spidell - San Jose, CA
>
>
>
> Hi all,
>
> I found the old discussion thread below while surfing for info on the
> angle drive for a BJ8.
>
> I have a new one on order since mine failed last week.
>
>
>
> Does anyone know the dimension of the washer mentioned, thickness of
> course most important?
>
> I want to know if I don't receive one with my order.
>
>
>
> Thanks, Peter Ehn
>
>
>
> PS.
>
> My drive "crashed" last week, and I think I actually reset the trip
> meter while driving as someone mentioned in the old thread. Don't know
> if this was the cause, but speedo and cable are OK and easy to spin by
> hand.
>
>
>
>
>
> Peter Ehn
> AH 3000 MKIII, 1967. BJ8 42208.
> Bromma/Stockholm, Sweden
> Phone: +46 708 33 72 97
> E-mail: peter.ehn at frontwalker.se <mailto:peter.ehn at frontwalker.se>
|