Peter,
Steel washer, .063 to .064
keep in mind that the angle drive usually breaks due to a frozen
speedo bearing.
John
At 07:31 PM 5/8/2012 +0200, Peter Ehn wrote:
>Thanks Bob for your answer. I've read this, but don't have time to
>order from Moss, living on the other side of the "pond". :-)
>
>Peter Ehn.
>+46 708 33 72 97
>peter.ehn at frontwalker.se
>
>(skickat frC%n min iPhone)
>
>8 maj 2012 kl. 19:27 skrev "Bob Spidell" <bspidell at comcast.net>:
>
> > Can't help on dimensions, but here's some info:
> >
> > http://www.mossmotors.com/graphics/products/PDF/021-511.pdf
> >
> > Bob
> >
> > --------------------------------
> > Bob Spidell - San Jose, CA
> >
> >
> >
> > Hi all,
> >
> > I found the old discussion thread below while surfing for info on the
> > angle drive for a BJ8.
> >
> > I have a new one on order since mine failed last week.
> >
> >
> >
> > Does anyone know the dimension of the washer mentioned, thickness of
> > course most important?
> >
> > I want to know if I don't receive one with my order.
> >
> >
> >
> > Thanks, Peter Ehn
> >
> >
> >
> > PS.
> >
> > My drive "crashed" last week, and I think I actually reset the trip
> > meter while driving as someone mentioned in the old thread. Don't know
> > if this was the cause, but speedo and cable are OK and easy to spin by
> > hand.
> >
> >
> >
> >
> >
> > Peter Ehn
> > AH 3000 MKIII, 1967. BJ8 42208.
> > Bromma/Stockholm, Sweden
> > Phone: +46 708 33 72 97
> > E-mail: peter.ehn at frontwalker.se <mailto:peter.ehn at frontwalker.se>
>_______________________________________________
>Support Team.Net http://www.team.net/donate.html
>Suggested annual donation $12.75
>Archive: http://www.team.net/archive
>Forums: http://www.team.net/forums
>
>Healeys at autox.team.net
>http://autox.team.net/mailman/listinfo/healeys
>
>Unsubscribe/Manage:
>http://autox.team.net/mailman/options/healeys/jmsdarch at sbcglobal.net
|