Crap. I thought I was doing it wrong. Got one. It's the only way to get to
them.
Greg
Sent from my iPhone.
On Nov 26, 2012, at 6:57 PM, Alan Seigrist <healey.nut@gmail.com> wrote:
> Greg -
>
> Unfortunately the BJ8 carbs must go on and off as a pair because of the
throttle cross shaft slots into the throttle levers on the carb shafts.
>
> I have found that using the shortie box wrench (from craftsman pro) is the
best way to get to those nuts under the rear carb.
>
>
http://www.craftsman.com/craftsman-professional-11-pc-standard-full-polish-12
/p-00944138000P?vName=Hand+Tools&cName=Wrenches&sName=Combination+Wrench+Sets
&prdNo=1&blockNo=1&blockType=L1
>
> Best,
>
> Alan
>
>
> On Tue, Nov 27, 2012 at 6:47 AM, Greg Mandas <gmandas@yahoo.com> wrote:
>> Do "You" remove/install the carbs on a BJ8 together as one unit or
separately?
>>
>> I do them together, but it's a bit difficult to get to the two bolts under
the rear carb.
>>
>> I'm assuming to replace them separately, you'd have to disassemble the
linkage and reset it afterwards.
>>
>> Greg
>> _______________________________________________
>> Support Team.Net http://www.team.net/donate.html
>> Suggested annual donation $12.75
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>>
>> Healeys@autox.team.net
>> http://autox.team.net/mailman/listinfo/healeys
>>
>> Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/healey.nut@gmail.com
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|