Use cup steel washers or bend steel washers, never use the split washers
with the soft brass nuts. These washer will make sure there is a
considerable load on the nut, preventing it from loosening (in theory).
If you want to use split lock washers, use a plain steel washer between
the nut and the split washer.
Kees Oudesluijs
NL
Op 21-12-2012 18:56, john spaur schreef:
> The parts book shows only plain steel washers and tall brass nuts to
> attach the manifolds to the head.
>
> Is a lock washer recommended?
>
> I have always used them but would like to know what the best practice is.
>
> John Spaur
> '62 BT7
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/coudesluijs@chello.nl
>
>
>
> -----
> Geen virus gevonden in dit bericht.
> Gecontroleerd door AVG - www.avg.com
> Versie: 2013.0.2805 / Virusdatabase: 2637/5974 - datum van uitgifte:
> 12/20/12
>
>
--
Kees Oudesluijs
Dorpsstraat 183
2995XG Heerjansdam
T: 078-677 1233
E: coudesluijs@chello.nl
Technische commissie Jensen Healey en GT
Het Jensen Genootschap Holland
www.jensenholland.nl
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|