--===============7441220839798816919==
boundary="----=_Part_9038460_1840496656.1551738873635"
------=_Part_9038460_1840496656.1551738873635
Content-Transfer-Encoding: quoted-printable
Sorry if this is a duplicate.
Bob,=C2=A01. Have you installed the washer that goes between the angle driv=
e & transmission? See parts book or Moss motors catalog.2. According Britis=
h Car Specialists, if the square section of the inner cable is too long it =
will cause binding. Check their website for tech tips for the specific spec=
ifications.3. Have you tried connecting a drill to the cable while it is co=
nnected to the speedometer to verify that there is no binding in the cable/=
speedometer?
Gary Hodson
-----Original Message-----
From: Robert Begani <rfbegani@gmail.com>
So as part of putting the tunnel and interior back together so I can go for=
a ride soon, I looked at the speedo angle gear. =C2=A0=C2=A0On the old gea=
r the short cable that fits into the trans had sheared off, so I installed =
a new angle gear.=C2=A0 Just to see if that was working I installed the sho=
rt piece of cable, turned on the engine, engaged the gear and looked down a=
nd saw the piece of cable spinning.=C2=A0 Then I took out the piece of cabl=
e and attached the speedo cable to the dash.=C2=A0 It was not spinning.=C2=
=A0 Interesting.=C2=A0 So I removed the cable from the housing and fit it i=
nto the angle drive gear and no movement.=C2=A0 Thinking it might be a prob=
lem of load, reinstalled the short piece, it spins even when I apply hand p=
ressure to the end.=C2=A0 Looking at the cable and the housing and the fitt=
ing of the cable up to the stop, etc. cannot figure why it does not spin.=
=C2=A0 Before I buy a new cable and housing do any of you have ideas? =C2=
=A0Bob Begani
------=_Part_9038460_1840496656.1551738873635
Content-Transfer-Encoding: quoted-printable
<font color=3D'black' size=3D'2' face=3D'arial'>
<div style=3D"font-family:arial,helvetica;font-size:10pt;color:black">Sorry=
if this is a duplicate.<br>
<br>
<div id=3D"yiv7370819245">
<div><font color=3D"black" face=3D"arial" size=3D"2">
</font>
<div>Bob, </div>
<div>1. Have you installed the washer that goes between the angle drive &am=
p; transmission? See parts book or Moss motors catalog.</div>
<div>2. According British Car Specialists, if the square section of the inn=
er cable is too long it will cause binding. Check their website for tech ti=
ps for the specific specifications.</div>
3. Have you tried connecting a drill to the cable while it is connected to =
the speedometer to verify that there is no binding in the cable/speedometer=
?<br clear=3D"none">
<div>Gary Hodson</div>
<div><br clear=3D"none">
</div>
<div style=3D"font-family:arial, helvetica;font-size:10pt;color:black;">---=
--Original Message-----<br clear=3D"none">
From: Robert Begani <rfbegani@gmail.com><br clear=3D"none"><br clear=
=3D"none">
<div class=3D"yiv7370819245yqt9870073885" id=3D"yiv7370819245yqt07171">
<div id=3D"yiv7370819245">
<div>
<div class=3D"yiv7370819245WordSection1">
<div class=3D"yiv7370819245MsoNormal"><span style=3D"font-size:12.0pt;">So =
as part of putting the tunnel and interior back together so I can go for a =
ride soon, I looked at the speedo angle gear. On the old gear t=
he short cable that fits into the trans had sheared off, so I installed a n=
ew angle gear. Just to see if that was working I installed the short =
piece of cable, turned on the engine, engaged the gear and looked down and =
saw the piece of cable spinning. Then I took out the piece of cable a=
nd attached the speedo cable to the dash. It was not spinning. =
Interesting. So I removed the cable from the housing and fit it into =
the angle drive gear and no movement. Thinking it might be a problem =
of load, reinstalled the short piece, it spins even when I apply hand press=
ure to the end. Looking at the cable and the housing and the fitting =
of the cable up to the stop, etc. cannot figure why it does not spin. =
Before I buy a new cable and housing do any of you have ideas?</span></div=
>
<div class=3D"yiv7370819245MsoNormal"><span style=3D"font-size:12.0pt;"> &n=
bsp;</span></div>
<div class=3D"yiv7370819245MsoNormal"><span style=3D"font-size:12.0pt;">Bob=
Begani</span></div>
</div>
</div>
</div>
</div>
<br clear=3D"none">
</div>
</div>
</div>
</div>
</font>
------=_Part_9038460_1840496656.1551738873635--
--===============7441220839798816919==
Content-Transfer-Encoding: 7bit
Content-Disposition: inline
_______________________________________________
Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
--===============7441220839798816919==--
|