Gents, this TF project car came with a SS muffler, new from Moss and made in
England. The input and output pipes on the unit itself are offset. My
question is what is the orientation of the offset when the whole thing is
bolted
down? The header pipe isn't quite the right location but it will fit.
I'm also a little concerned that the muffler is pretty close to the petrol
pipe...and concern here about atomizing the petrol??
Tnx
Terry
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|