Hot if the head is iron, cold if aluminium.
Bob
On Mon, 14 May 2007 19:15:30 +1200 "Douglas Ormrod"
<Douglas.Ormrod@neurological.org.nz> writes:
> Giday T typers
>
> Done a few hundred miles in the TD now so thought I would torque up
> the
> head nuts (engine was fully reconditioned). I am not sure if this
> should
> be done with the engine hot or cold?
>
> Thanks as always
>
> Douglas
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|