On Thu, 11 Jan 1996, David Councill wrote:
> In a related note, an old MG mechanic showed me an unusual trick some ten
> years ago. By drilling a hole in the transmission bell housing of a
> diameter of over an inch (25 cm), one can access the pressure plate bolts,
> undo them, and pull the transmission out without removing the engine. Or in
> my case, separate the engine and transmission to get to the clutch.
I don't understand... why must the pressure plate bolts be undone to pull
the trans?
Ray Gibbons Dept. of Molecular Physiology & Biophysics
Univ. of Vermont College of Medicine, Burlington, VT
gibbons@northpole.med.uvm.edu (802) 656-8910
|