ENRIQUE CLAURE wrote:
>
> Hello fellow MGers, I purchased the Eastwood Hot Coat powder coating system.
> Unbeleiveably I found in the local paper a guy that was selling a 1 cubic
> meter oven that goes up to 300ºc for 500U$ if you dont know, these ovens
> cost 3500$ upward used! OK so I lucked out. Next I got a small vacuum
> pressue pump that puts out 30PSI that is fine for this purpose. Now I have
> to determine what to paint that in turn has led me to ask the following:
>
> I plan to paint the intake manifold (weber) and the exhause manifold with
> powder coating system. The max temp that the paint will withstand is 205ºC
> or 400F or so. Does anybody know if these parts when operating reach these
> temps? Am I in the safe zone here? Thanks to all Enrique
You won't even be in the same ballpark with the exhaust, which reaches
1200 degrees plus. John
|