| To: | tboicey@brit.ca |
|---|---|
| Subject: | Re: Door alignment |
| From: | grunt14@juno.com |
| Date: | Sat, 9 May 1998 10:56:03 -0400 |
Place a block of wood and a small jack under the rear of the door, partly open try jacking the door up , repeat till it fits, or you could shim the lower hindge,use washers betweem the hindge and the door with the screws through them. This will both raise the bottom of the door and give you more space at the front,If you must even use longer screws. Carl E. |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Trivia Alert, WSpohn4 |
|---|---|
| Next by Date: | Re: Electrically Dead MG, grunt14 |
| Previous by Thread: | Door alignment, Chris Delling |
| Next by Thread: | MGB pre '69 wanted, Trond Vidar Olsen |
| Indexes: | [Date] [Thread] [Top] [All Lists] |