| To: | "Richard A. Boris" <borisri@earthlink.net> |
|---|---|
| Subject: | Re: MGB Banjo Hub Seals |
| From: | Barney Gaylord <barneymg@ntsource.com> |
| Date: | Fri, 19 Jun 1998 02:29:20 |
At 11:00 PM 6/18/98 +0100, Rich Boris wrote: >.... Banjo axle hub seals; >should the seal be lubricated with grease/silicone, etc; prior to installtion into the hub? Are there any tricks with this installation? No and no. Remove the old seal, clean the hub, press in the new seal, and lubricate the lip edge and mating axle seal surface before final assembly. Piece-o-cake, Barney Gaylord 1958 MGA with a banjo axle |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: rounded-off bolt, Barney Gaylord |
|---|---|
| Next by Date: | Re: Modern Sports Cars, Mike Gigante |
| Previous by Thread: | MGB Banjo Hub Seals, Richard A. Boris |
| Next by Thread: | wheels & fan sensors, Jim Stuart |
| Indexes: | [Date] [Thread] [Top] [All Lists] |