mgs
[Top] [All Lists]

Re: Bearing spacer, front hub

To: Andrew Errington <ame@synaptics.com>
Subject: Re: Bearing spacer, front hub
From: john peloquin <peloquin@galaxy.ucr.edu>
Date: Tue, 14 Jul 1998 15:32:06 -0700 (PDT)
Dear Andrew,

I just put a new spacer in my '70 mgb. I think it will, but I can't
say for sure. I was able to put new bearings in without worrying about
this.

"Never Ascribe to Malice that which can be explained by Ignorance."
John J. Peloquin
Entomology, University of California, Riverside, CA 92521

On Tue, 14 Jul 1998, Andrew Errington wrote:

> Hi,
> 
> I have a quick question.  Will the bearing spacer inside the front hub pass
> through the outer race of the inner bearing (!).  The reason for asking is
> that I have new front hubs and bearings and I should like to drift the outer
> races of the inner and outer bearings into place, but of course I cannot fit
> the bearing spacer until I rescue it after taking the old hubs off the car.
> 
> Many thanks,
> 
> Andy
> ---
> '69 B Roadster
> 
> 


<Prev in Thread] Current Thread [Next in Thread>