mgs
[Top] [All Lists]

RE: That #@*&^$!!! choke handle... Help wanted

To: "Hert" <hert@wxs.nl>, "MG Mailing List" <mgs@Autox.Team.Net>
Subject: RE: That #@*&^$!!! choke handle... Help wanted
From: "RossOvercash" <jroverca@tiac.net>
Date: Mon, 17 Aug 1998 06:35:55 -0400
Peter,

I too have replaced this piece.  I was able to do it by removing the
airvents in the center of the facia.  There is a nut that holds the choke
handle assembly in the hole.  This will have to be removed, and the wire
connecting to the carburator linkage removed.  Then the while thing will
slide out. (one piece construction). Installation is the reverse, it helps
to have small hands (I don't).  Good luck

Safety Fast!!

Ross Overcash, 74B, NAMGBR 2-1172, Ayer, MA
http://www.tiac.net/users/jroverca/index.htm


> -----Original Message-----
> From: owner-mgs@autox.team.net [mailto:owner-mgs@autox.team.net]On
> Behalf Of Hert
> Sent: Sunday, August 16, 1998 3:50 PM
> To: MG Mailing List
> Subject: That #@*&^$!!! choke handle... Help wanted
>
>
> Does anyone know the easiest way to replace the choke pull & twist
> handle on a 74 CBB? Today I snapped it off, behind the fascia, the metal
> looked pretty tired and scaffed on the side.
>
> The procedure in the workplace manual to take off the whole fascia looks
> gruesome, 14 steps with a couple of hundred items to loosen. I was
> wondering if I could reach it by first removing the glovebox and then
> the upright airvents. What would I find once I got in?
>
> Thanks in advance,
>
> Peter
> slow starter B
>
>
>


<Prev in Thread] Current Thread [Next in Thread>