Re: Polyurethane "A" arm bushings vs V-8 bushings

[RJohn50603@aol.com]

In a message dated 1/19/99 1:04:47 AM EST, RJohn50603@aol.com writes:

<< By the way, if you have corrosion from V-8 bushings as I did on the first
side
 I did, you can make a nice sleeve from some hard drawn 5/8" O D copper
tubing.
 The original O D of the wishbone pivot is 5/8" (.650"). Saves $100. Just
don't
 turn too much material off of the wishbone pivots.
 >>

Duh, 5/8" is .625" not .650". Struck me this morning as I was waking up. What
was I thinking of?

R. Johnson - Dallas