Oil pressure in rebuilt engine

[Larry Hoy <larryhoy@cwix.com>]

I just finished "freshening" an MGB engine.  I thought I would try to turn it
over and check oil pressure before I install it in the car, the engine is
presently on an engine stand.  I'm looking for suggestions, and have thoughts of
my own.

1  Throw 12 volts on the starter and letter crank.

2  Use a bolt on the distributor drive (5/16 fine?) and twist it with an impact
wrench (wrong direction?).

Any thoughts?

Larry Hoy
http://home.cwix.com/~larryhoy@cwix.com/