mgs
[Top] [All Lists]

Re: Banjo axle, wire wheel hub removal

To: Bill Schooler <schooler@erols.com>
Subject: Re: Banjo axle, wire wheel hub removal
From: Kevin Sullivan <kevins@khoral.com>
Date: Mon, 15 Feb 1999 14:15:31 -0700 (MST)
On Mon, 15 Feb 1999, Bill Schooler wrote:

> Took half shaft/hub and new hub to machinist.  He has called twice so
> far.  First time to report that 10 tons of pressure hadn't budged
> anything.  Said he'd try some serious heat.  Second call was to report
> no success after heat and 12 tons of pressure.  (And I was banging on
> the assembly with an MG knockoff hammer?)

Yep.  Take it to a place that works on the big rigs' drive lines.  No
problem for them.

> I suppose the alternative is to throw more money at it and buy new half
> shafts, but this is getting ridiculous!

One guy I know was putting in a B rear end so he went with new B half
shafts.

Kevin Sullivan             kevins@khoral.com
Khoral Research Inc.       www.khoral.com/staff/kevins/mgstuff
Albuquerque NM USA 

1960 MGA           "Baby"
1957 Magnette ZB   "Pup"
1959 Magnette ZB   "P2"


<Prev in Thread] Current Thread [Next in Thread>