...way too hard...unless you don't mind the vibration
polyurothane are hareder than stock as well but are a happy median
between crappy melt in you hand stock rubber and the rock hard Prothane
bushings.
Leave those prothanes to the racers
Paul Tegler
Twin 73' MGB GTs YB and OB
YB born 8/72 (Primrose Yellow) Yellow BGT
OB born 1/73 (Blaze Red) Orange BGT
North of Annapolis, South of Baltimore
email: wizardz@maxinter.net
http://www.amdyne.net/~ptegler/mgmain.htm
-----Original Message-----
From: Michael Graziano <mgrazian@ltcm.com>
To: Spridgets (E-mail) <spridgets@autox.team.net>; MGList (E-mail)
<mgs@autox.team.net>
Date: Wednesday, April 28, 1999 3:55 PM
Subject: "Prothane" Poly Bushings
I'd like to eventually change the front bushings on the Midget. Has anyone
any experience with the Prothane Poy bushings Moss has in their catalog?
If I go by the catalog, I need 4 for the front lower control arm, 4 for the
upper control arm, and 2 on my sway bar. Is this correct?
Michael
_____________________________________
/ \
| Michael Graziano |
| Long Term Capital Management L.P. |
| Phone: 203-552-5706 |
| Fax: 203-553-5869 |
| Email: mgrazian@ltcm.com |
\_____________________________________/
|