Is the gap between glass and seal too big? Try adjusting the postion of the
glass runners so the glass is a bit closer.
PaulH.
http://freespace.virgin.net/paul.hunt1/
-----Original Message-----
From: Jones, Mark <MJones@ngl.ca>
To: 'mgs@autox.team.net' <mgs@autox.team.net>
Date: 14 June 1999 13:00
Subject: Door Glass Seal
>I replaced the Driver's side door glass seal this weekend and I am having
>the problem that when I crank the window down the seal is pulled down and
>turned under by the window due to their being too much friction between the
>glass and the rubber seal. Has anyone else had this problem? Any
>suggestions on how to fix it?
>
>Also some people have complained that their rubber seals were of poor
>quality and were replacing them every few years. The ones I received were
>made in the UK by Rover and seem to be of very good quality. I should also
>mentioned that somewhere I read to put masking tape over the seal before
>reinstalling the glass. I did this and it made replacing the glass very
>easy; an excellent tip.
>
>Now I just have to fix/replace the heater valve, voltage stabilizer, park
>lights, ....
>
>Mark
>73 MGB GT
>
|