At 8:18 AM -0800 1/16/01, stevep wrote:
>My MGA project has rather flimsy wood floor boards. the PO did a nice job
>of installing but there is alot of flex. It appears that it is 3/8" thick,
>is this correct? Recommendations have been to use marine grade plywood but
>I can find no reference to thickness.
>
>How thick are your boards
>
>
>Steve Petrosky
>58A, 78B
1/2". If you can't find marine you might use exterior grade and do a
bit of sanding. The glue is the same, the difference is in the finish.
--
Bob Shaw
Check out Shaw's Garage at http://www.mlcltd.com/shawsgarage/
My British Car is NOT leaky - it's merely marking its territory.
|