mgs
[Top] [All Lists]

Clutch bleed problems ...

To: "'spridgets@autox.team.net'" <spridgets@autox.team.net>,
Subject: Clutch bleed problems ...
From: "Louis Mehr (EML)" <Louis.Mehr@eml.ericsson.se>
Date: Mon, 23 Apr 2001 08:39:12 +0200
Good Morning Spridget and MG World,

 
I've had quite a bit of trouble bleeding my clutch hydraulics over the weekend.

(i) The Haynes manual does not mention the access hole in the driver's 
footwell.  Until I discovered this from a note in the Moss catalogue I was 
struggling underneath the car.

(ii) It was very hard to turn the bleed nipple with the bleed tube attached as  
access was a big problem.  It looks like a ratchet spanner would really help 
here.  What spanner model/make will allow me to turn the bleed nipple whilst 
the tube is attached given this limited access i.e. what do the  listers use ?

(iii) After finally charging up the circuit with fluid and bleeding using 
Easibleed I found that the clutch pedal did nothing.  There was no sign of any 
motion of the clutch slave when the pedal was pressed and the pedal pressure 
felt just the same as it did with no fluid in it.   There were no obvious fluid 
leaks and the level of fluid in the reservoir was constant.  What is the 
diagnostic procedure here ?  I'd like to pinpoint the fault before stripdown of 
the master/slave cylinders.

Thanks in advance,

Regards

Louis Mehr
Manchester, England
1971 A-H Sprite

///
///  mgs@autox.team.net mailing list
///  (If they are dupes, this trailer may also catch them.)


<Prev in Thread] Current Thread [Next in Thread>