Ummm.
On a B the end of the hose that goes to the brake caliper is sealed
with a copper crush washer. When installing the brake calipers you will
need one crush washer per side of vehicle. Nice of them to send extras.
Kelvin.
>
> There should be no copper washers used in a B. Most cars use
> a banjo fitting
> to connect the brake hose to the caliper and require a copper
> washer on each
> side of the fitting. MG's use s system where the tapered end
> of the brake
> hose seals with the bore of the hole where the brake hose
> enters the caliper.
This statement is incorrect. Not sure where the confusion lies, all
the B and Midget Lockheed calipers and B clutch slave cylinder use the 3/8 X
24 UNF male thread sealed with a copper washer.
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|