Did you recheck the end-float on the hubs afterwards? With different
spindles even though the rest of the parts are the same you may need to make
some adjustments.
"I have no idea why they were incorrectly placed" Murphy's Law - if it is
possible to get something the wrong way round, then someone, somewhere,
sometime, will.
----- Original Message -----
From: "joe gorman" <gormanj@ywave.com>
To: <mgs@autox.team.net>
Sent: Sunday, May 11, 2003 5:41 AM
Subject: Re: Wire Wheel Hubs
> Thanks for all the advice. This afternoon I swapped the right and left
hubs.
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|