None required.
on 7/12/04 6:40 PM, John Di Fede at difejo@optonline.net wrote:
> List,
>
> What is the list's consensus regarding the use of gasket sealant when
> installing carburetors on your MGB? I am talking about a dual carb set up
> using the six gaskets installed between the heat shield and the spacer blocks
> behind the carbs.
>
> Sealant or no sealant? Why or why not?
>
> If you use sealant what do you use, and how do you remove it from the spacing
> blocks and the heat shield the next time you remove the carbs?
>
>
> Thanks.
>
> John Di Fede
> Hopewell Junction, NY 12533
> difejo@optonline.net
>
--
Max Heim
'66 MGB GHN3L76149
If you're near Mountain View, CA,
it's the primer red one with chrome wires
|