Re: Lost low beam on rh Headlight

["Paul Hunt" <paul.hunt1@blueyonder.co.uk>]

Not necessarily.  If you remove the load and check for voltage with a
typical voltmeter you could well see 12v displayed, even if there is a bad
connection that will prevent the bulb glowing at all when connected.  Always
check voltages with the load connected.

PaulH.

----- Original Message -----
From: "Barney Gaylord" <barneymg@MGAguru.com>
To: "James Schulte" <schultejim@msn.com>; <Mgs@Autox.Team.Net>; "MG Club
Philadelphia" <Philly_MG_Club@yahoogroups.com>
Sent: Sunday, November 28, 2004 8:44 PM
Subject: Re: Lost low beam on rh Headlight


> Remove the bulb.  Check voltage in the harness connector.  If you have
> power the bulb is bad.  If no power start tracing back to prior connectors
> in the harness to see where you lost the connection.