mgs
[Top] [All Lists]

RE: Another electrical question

To: "'Paul Hunt'" <paul.hunt1@blueyonder.co.uk>, <mgs@autox.team.net>
Subject: RE: Another electrical question
From: "Howard Battan" <battanhr@comcast.net>
Date: Wed, 27 Jul 2005 17:18:41 -0700
Paul, after looking at it again, and trying to remember what I did when
trying to get the wiring sorted out the first few days on my ownership, I
may have been the one that connected the heavy green wire to the unused
spade lug on the fuse box while trying to chase down the turn signal
problem, etc. (Gulp!) and fed power back to the lighting circuits. Removing
the green wire from the fuse box has solved the issue of marker and running
lights being on whenever the key is on.

One thing - for a 'B' factory wired for the Zenith/Stromberg carb, why
wouldn't the manifold heater wire have been contained in the wiring loom?

Howard Battan
'57 MGA
'79 MGB

-----Original Message-----
From: Paul Hunt [mailto:paul.hunt1@blueyonder.co.uk] 
Sent: Wednesday, July 27, 2005 11:04 AM
To: Howard Battan; mgs@autox.team.net
Subject: Re: Another electrical question

The spade on the fusebox that is not normally used is connected by a link
internal to the fusebox to both of the top two fuses i.e. the parking lights
both sides.  It sounds like someone has added a wire from that terminal to a
circuit that is live when the ignition is on (either a white or a green).
The inlet manifold heater *is* supposed to be powered from a green which
goes back to a 4-way bullet connector that will be in the vicinity of the
brake light switch, other greens go from that connector to the brake light
switch and the electric screen washer, the 4th green in that connector is
the 12v supply from the 2nd fuse up in the fusebox.  If you have 12v on all
those components with this extra thick green wire disconnected from the
fusebox then it should be discarded.  If it goes into the loom it must have
been re-wrapped, it isn't a factory wire.  It could be that the original
green feed to something developed a bad connection and a PO added the extra
wire as a quick and dirty way of bypassing it, sticking it on the only spare
spade on the fusebox.  With the fault on it would only have done its job
with the lights on, so maybe that is how he drove.  Maybe that fault has
since cleared itself.

PaulH.




<Prev in Thread] Current Thread [Next in Thread>