mgs
[Top] [All Lists]

Re: Peco installation

To: <ptegler@cablespeed.com>, "MG List" <mgs@autox.team.net>
Subject: Re: Peco installation
From: "Larry Daniels" <ladaniels@sbcglobal.net>
Date: Sun, 15 Oct 2006 17:15:10 -0500
That's what I was afraid of.  Either lift the motor a bit or remove the 
steering column -- or both.

Did you end up dropping it in or lifting it up from the bottom?

LD


----- Original Message ----- 
From: <ptegler@cablespeed.com>
To: "Larry Daniels" <ladaniels@sbcglobal.net>; "MG List" 
<mgs@autox.team.net>
Sent: Sunday, October 15, 2006 5:11 PM
Subject: Re: Peco installation


Even on my '73 BGT I had to lift the motor off it's mount about 1-1.5" to
drop it down into place. But fully mounted there are no clearance issues.
I've have the complete 'big bore' system on my year round daily driver BGT
since '98.   I did just recently replace the rear box as it finally started
blowing a seam. But the rest of the pipe is still there and in reasonable
shape.

Paul Tegler
ptegler@cablespeed.com
www.teglerizer.com
----- Original Message ----- 
From: "Larry Daniels" <ladaniels@sbcglobal.net>
To: "MG List" <mgs@autox.team.net>
Sent: Sunday, October 15, 2006 4:21 PM
Subject: Peco installation


> Trying to install a Peco header on a 79 MGB.   Won't go in from the top.
> Doesn't seem to want to go in from the bottom either.
>
> Any secrets here?
>
>
> Larry Daniels
>
> 79 MGB LE
> 72 Midget
> 60 Bugeye
> 67 Austin A60 Pickup
>
> "You only need two tools: WD-40 and Duct Tape. If it
> doesn't move and should, use the WD-40. If it
> shouldn't move and does, use the duct tape."
>
> Your messages not reaching the list?
> Check out http://www.team.net/posting.html




<Prev in Thread] Current Thread [Next in Thread>