mgs
[Top] [All Lists]

Re: [Mgs] seat removal question

To: mgs@autox.team.net
Subject: Re: [Mgs] seat removal question
From: RampantNM@aol.com
Date: Thu, 28 Feb 2008 15:25:10 EST
In a message dated 2/28/2008 7:08:30 AM Mountain Standard Time,  
dwillner@ptd.net writes:

Manual  says push seat
forward, remove two bolts, push seat back, remove two  bolts....is this it, 4
bolts?  I assume the tracks are bolted to the  seats in the middle somewhere 
as
well?   Thanks




The manual is correct.  The rear two bolts are a bit difficult to  reach, but 
there are only four.  Careful when you lift the seat out as the  tracks may 
just fall off, as well as the spacers, and the aluminum washers in  the spacers 
that the bolts go through.
 
Regards,

Robert B. Houston

74.5 MGBGT
73 MG  Midget

As he stared at her ample bosom, he daydreamed of the dual  Skinners Union
carburetors in his vintage MG, highly functional yet  pleasingly formed, 
perched prominently on top of the intake manifold, aching for  experienced 
hands, 
the small knurled caps of the oil dampeners begging to be  inspected and 
adjusted as
described in chapter seven of the Haynes shop  manual.




**************Ideas to please picky eaters. Watch video on AOL Living.      
(http://living.aol.com/video/how-to-please-your-picky-eater/rachel-campos-duffy/
2050827?NCID=aolcmp00300000002598)
_______________________________________________
Support Team.Net  http://www.team.net/donate.html




Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs

http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>