Why not? Do you mean there is not enough thread in the adjuster to get it
where you want to go?
Hard to believe you shaved the head that much, that you need a shorter
pushrod. Maybe the threads are just fouled. Swap with a different rocker and
try again?
on 6/29/09 9:24 AM, Tom Gunderson at thgun@comporium.net wrote:
> I cannot adjust the #8 valve after the head had been machined. Any
> ideas?
>
--
Max Heim
'66 MGB GHN3L76149
If you're near Mountain View, CA,
it's the primer red one with chrome wires
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs
http://www.team.net/archive
|