[Mgs] setting valves after head machining / 1500 MGA

mgs

[Mgs] setting valves after head machining / 1500 MGA

from [thgun]

To:	mgs@autox.team.net
Subject:	[Mgs] setting valves after head machining / 1500 MGA
From:	<thgun@comporium.net>
Date:	Mon, 13 Jul 2009 11:03:08 -0400 (EDT)

I have talked to a few people about this and I am still not clear as to how to 
go about fixing my problem. I purchased a redone head. Now a few of the valves 
are too tight to adjust. Can I use shims all the way across to raise the rocker 
assembly? If so where can I get them? Any other tips.
Thanks for the help,
Tom Gunderson, 1957 MGA 1500 rst
_______________________________________________
Support Team.Net  http://www.team.net/donate.html




Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs

http://www.team.net/archive

[More with this subject...]

<Prev in Thread]	Current Thread	[Next in Thread>
[Mgs] setting valves after head machining / 1500 MGA, thgun <= Re: [Mgs] setting valves after head machining / 1500 MGA, WSpohn4 Re: [Mgs] setting valves after head machining / 1500 MGA, Max Heim Re: [Mgs] setting valves after head machining / 1500 MGA, Max Heim Re: [Mgs] setting valves after head machining / 1500 MGA, Barney Gaylord Re: [Mgs] setting valves after head machining / 1500 MGA, Max Heim Re: [Mgs] setting valves after head machining / 1500 MGA, Jim Juhas Re: [Mgs] setting valves after head machining / 1500 MGA, Barney Gaylord Re: [Mgs] setting valves after head machining / 1500 MGA, Paul Hunt Re: [Mgs] setting valves after head machining / 1500 MGA, The Roxter

Previous by Date:	Re: [Mgs] AOL and Team.Net, Paul Root
Next by Date:	Re: [Mgs] AOL and Team.Net, Barrie Robinson
Previous by Thread:	[Mgs] Related to No Start Condition...., Dan DiBiase
Next by Thread:	Re: [Mgs] setting valves after head machining / 1500 MGA, WSpohn4
Indexes:	[Date] [Thread] [Top] [All Lists]