The flat one is 2.5". The other plate is 2.75", in fact, the location of
the plate relative to the bottom posts is identical on both, but the
piece from the 64B is a bit longer thus accounting for the extra 1/4" at
the apex.
-----Original Message-----
From: Paul Hunt [mailto:paul.hunt1@blueyonder.co.uk]
Sent: Saturday, April 24, 2010 9:39 AM
To: Councill, David; MG-MGB@yahoogroups.com; MG Digest
Subject: Re: [Mgs] [MG-MGB] latch problem
Out of interest, what's the distance from the bottom of the bolt-through
plate to the top of the flat loop on your flat-topped one (mine was
2.5"),
and is yours curved in the other plane (looking down on the top of the
loop)
like mine?
----- Original Message -----
I guess I should have put the bolt-through plate in position in the
picture to demonstrate more...
_______________________________________________
Mgs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|