Re: [Mgs] MGA air hoses?

[David Breneman <david_breneman@yahoo.com>]

 From: Barney Gaylord <barneymg@mgaguru.com>


> It is tough to tke a picture
in that area with an assembled car.  I can tell you 
> that the original bolt
for the forward P-clip goes through the horizontal air 
> pan in the outboard
corner near the body mount.  You need to form the hose to 
> fit first, push
it onto the top connector pipe, then position the P-clip and 
> install the
bolt last.  It is a lot easier if the grille is not in place at the 
> time. 
That bolt has given me so much grief over the years that I drilled 
> another
hole inboard from the hose and turned the P-clip around to make life 
>
easier.

This is the way mine was done, at the bottom of the page linked
below.
I seem to remember Barney commenting on this a few years ago, but I
don't remember if he said if it's correct or it's somehow wrong...
http://tildebang.com/mg/index34.html
_______________________________________________

Mgs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe: 
http://autox.team.net/mailman/options/mgs/mgs-archive@autox.team.net