The bad news is that if opening the bleed valve on the slave cylinder
doesn't let the throwout arm retract, the engine/gearbox probably need
to come back out so that you can see why the clutch disengaged when you
cinched the gearbox up to the engine. Has this engine/gearbox combo
worked before?
CR
On 10/25/2012 3:19 AM, Larry Colen wrote:
> Good news:
> http://www.flickriver.com/photos/ellarsee/sets/72157631848931452/
>
> Jasmine's motor is in place.
>
> Bad news, the clutch doesn't seem to be connecting the transmission to the fly
> wheel. When it first went in, moving the car back and forth, in gear, would
> move the engine. But there was about a 1/2" gap between the engine and the
> transmission. I put bolts through the holes to cinch it down, and it closed
> the gap with little problem. Not loud sproings like I busted something, or
> anything like that.
_______________________________________________
Mgs@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/mgs/mharc@autox.team.net
|