mgs
[Top] [All Lists]

[Mgs] Got the car out yesterday - today was bad.

To: mgs@autox.team.net
Subject: [Mgs] Got the car out yesterday - today was bad.
From: Paul Root via Mgs <mgs@autox.team.net>
Date: Sat, 12 Mar 2016 19:00:56 -0600
Delivered-to: mharc@autox.team.net
Delivered-to: mgs@autox.team.net
My son and I got the MG out yesterday, after charging the battery for a day and 
a half. It got it started and home. But I was planning on replacing the 
battery, it wouldnâ??t hold a charge at the end of the season last year.

Afterward, he and my wife went out shopping, he needed somethings before going 
back to college today. Anyway, they both thought the car sounded funny starting 
for the return trip. So they decided not to take the freeway. Probably smart.

Half way, it stalled on them and wouldnâ??t restart. He punched it across the 4 
lane road and up a little incline to a parking lot, and the called me. I came 
to the rescue, such as it was. Battery pretty much dead, we bump started it and 
got it home. Charged the battery over night, and this morning, tried starting 
it. The starter spun but did not engage, great.   I pulled the battery and went 
and got a new one. I had a group 26R in it, but decided to get the â??properâ?? 
group 24. I think that was a mistake. It fits, but with no room for error. And 
I had an error, my mounting bracket for the battery had threaded rods that were 
just too short for the group 24. Back to the store for longer rods.

While there, I talked with the guy behind the counter, we both said it sounded 
like the solenoid not engaging, so after finally getting the battery secured, I 
pulled the starter, and back to the store again. 

It tested fine.  Then the guy noticed the teeth were chewed up. 

I think the funny sound was the starter was still spinning and bouncing off the 
flywheel gear ring. 

I tried looking down in the starter hole, and it sure looks like the teeth are 
angled all the way around. I bumped the engine around.

So my options are replacing the ring gear and replacing the fly wheel. A 
machine shop can replace ring gears right?

Iâ??m in the twin cities, so is that something Qualtity Coaches does,  or do 
they just send it to a machine shop?

I guess Iâ??m pulling the engine.   Let the engine alone/engine and 
transmission debate begin!


Paul.

_______________________________________________

Mgs@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe: http://autox.team.net/mailman/options/mgs/mharc@autox.team.net
<Prev in Thread] Current Thread [Next in Thread>