----------
> From: Ken Gano <kengano@advant.com>
> To: Chad Jester <triumph@igc.net>
> Subject: Re: TR6 - Body Removal
> Date: Friday, October 18, 1996 11:11 PM
>
> Local machine shop constructed a "rotisserie". Basically, It's two
> oversized engine stands with a homemade, light weight "frame" attaching
the
> body attachment points. Whole thing cost less than $500 and it's on
wheels
> so you can push it around the shop. Very handy. Sure hope it all fits
> together at the end.
>
> Ken Gano
> kengano@advant.com
> downstate Illinois USA
> TR3A TS57756 (in pieces)
>
> ----------
> > From: Chad Jester <triumph@igc.net>
> > To: triumphs@autox.team.net
> > Subject: TR6 - Body Removal
> > Date: Monday, October 14, 1996 8:44 AM
> >
> > List,
> >
> > I'm ready to remove the body on my TR6. Can anyone suggest a good
> > way to support it while it is off the frame? I need to have access to
> > the bottom side to complete installation of the new floor pans.
> >
> > I have already welded braces into the door jams to keep the body from
> > folding in half;)
> >
> > Thanks,
> >
> > Chad
|