| To: | keithka@microsoft.com |
|---|---|
| Subject: | Re: Tool questions |
| From: | george_mcewen@juno.com (George E. McEweb) |
| Date: | Sun, 26 Oct 1997 15:15:11 -0500 |
were'nt the 12 point sockets useable for the old four corner bolts. These were on old machinery at one time. I have also wondered if I should buy some for this reason. I personaly like the six point sockets. |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [Non-MG] Dremel tool - Deed is done! Part Deux, Art Pfenninger |
|---|---|
| Next by Date: | Re: [Non-MG] Dremel tool - Deed is done! Part Deux, Carol |
| Previous by Thread: | Re: Tool questions, Steve N |
| Next by Thread: | Re: Re: Tool questions, JackiHarry |
| Indexes: | [Date] [Thread] [Top] [All Lists] |