shop-talk
[Top] [All Lists]

Re: RotoZip Saw

To: Shop Talk <shop-talk@autox.team.net>
Subject: Re: RotoZip Saw
From: James Babcock <jbabcoc@yahoo.com>
Date: Mon, 11 Jan 1999 18:33:25 -0800 (PST)
The rotozip is nice because it has a depth stop, but I used an electric
die grinder with a rotozip bit when I did some drywall recently.  I
found
the bits in the tool crib at Home Depot.  Rotozip makes several
different bits
including carbide rasps that will cut/shape almost anything.  Using it
certainly was easier than measuring, but it's a good idea
to push the electrical wires well back into the box before hanging
the drywall.  The rotozip bit will tear up the wire insulation if you
hit it.

Jim Babcock

---Douglas Shook <shook@usc.edu> wrote:
> 
> I mentioned the rotozip saw I got for Christmas and the furnance
install
> where I found it so handy. Here is rotozip's url:
> 
> http://www.rotozip.com/
> 
> Since it was a gift, I'm not certain of the price, but I think it was
> around $60. It seems very robust, though not much heavier than a
> flashlight.  It consumes 4 amps and runs at 30,000 RPM.  I think it is
> impossible to stall it, or even slow it down while using it.  It
> exhausts away from you so you don't get a face full of dust.
> 
> It does generate some fine dust, though, and it "sings" quite a tune
at
> 30K RPM.
> 
> I have no financial interest in this company, and only found out about
> it on 12/25/98.
> 
> I do like it very much, though.
> 
> doug
> 

==
James A. Babcock, Software Engineer      (jbabcoc@yahoo.com)
Realtime Embedded Systems Specialist   pager: (703) 706-8722
'80 Triumph TR7                        '87 Dodge Dakota 4x4
'88 Honda Prelude 2.0Si                '92 Honda Accord LX




<Prev in Thread] Current Thread [Next in Thread>